240W 16 Port PoE Din Rail 10G Managed Switch
Model Name
STI-21616XGGPM(L3)
Key Features
- 16*10/100/1000Base-T RJ45 PoE, 2*1G/2.5G/10GBase-X SFP+ slots
- Redundant power 44-57V input with polarity reverse/over-voltage/over-current protection
- Support one digital output for relay alarm (terminal block Pin 5/6)
- Comply with IEEE802.3af PoE and IEEE802.3at PoE+ standard
- Layer 3 features: Supports static and dynamic routing, RIP, OSPF, BGP4, ECMP, VRRP
- Layer 2 features: VLAN/VLAN Classification/QinQ/STP, RSTP, MSTP/Port Mirroring/DHCP/Multicast/ACL/IGMP/QoS/LLDP/802.1X/Dying Gasp/SFP DDM/IPV6 management/PoE management/Web/SNMP/Telnet/TFTP/Web upgrading
- Support G.8032 ERPS protocol, recovery time ≤20ms
- Support 6KV surge protection and ESD: Air-15kV, Contact-8kV Protection
- IP40 fan-less and Din-rail hardware design
- Operation temperature: -40 ℃ ~+75℃
With above features, it is an ideal solution for IP Surveillance, wind, electricity, assembly automation, subway PIS, power SCADA, sewage treatment, metallurgy, intelligent transportation, rail transportation, military and other industries.
Specification
Product Name |
18 port Hybrid Rate Layer 3 Managed Industrial Ethernet PoE Switch |
Port |
16*10/100/1000Base-T RJ45 PoE 2*1G/2.5G/10GBase-X SFP+ 1*RJ45 Console port(115200,8,N,1) |
Alarm port |
One relay output for power failure Alarm relay current carry ability: 1A@24VDC |
Network Medium |
10BASE-T: Cat 3, 4, 5 or above UTP(≤100 meter) 100BASE-TX: Cat 5 or above UTP (≤100 meter) 1000BASE-TX: Cat5 or above UTP (≤100 meter) |
Network protocol |
IEEE 802.3 10Base-T Ethernet IEEE 802.3u 100Base-TX Ethernet IEEE 802.3ab 1000Base-T Ethernet IEEE 802.3z 1000Base-X Ethernet IEEE802.3x Flow Control and Back Pressure IEEE 802.1D Spanning Tree Protocol IEEE 802.1w Rapid Spanning Tree Protocol IEEE 802.1Q VLAN ITU-T G.8032 ERPS IEEE 802.1X Port Authentication Network Control IEEE 802.1ab LLDP IEEE 802.3ad LACP IEEE802.3af PoE IEEE802.3at PoE+ |
Fiber Option |
SFP Plugable Module(LC) SM: 1310nm/1550nm, 20Km; 1490nm/1550nm, 40~100Km MM: 1310nm, 2Km; 850nm, 500-meter |
Switching Capacity |
72Gbps |
Throughput |
107.13Mpps |
Packet Buffer |
12M |
MAC Address |
16K |
VLAN |
4K |
Jumbo Frame |
10Kbytes |
Transfer Mode |
Store and forward, forwarding delay<5us |
MDX/MIDX |
Support |
Watchdog |
Support |
MTBF |
200,000 hours |
PoE Protocol |
IEEE802.3af(15.4W), IEEE802.3at(30W) |
PoE Wiring |
1/2(+), 3/6(-) |
PoE Budget |
240W |
Power Voltage |
Input Voltage: DC 44-57V(PoE af), DC 52-57V(PoE at) Redundant power input Removable 6 PIN Industrial Terminal Block, pin 5/6 for relay alarm output |
Input current |
5.8A Max |
Total power consumption |
Full loading without PoE ≤18W |
Reverse polarity protection |
Support |
Over-voltage protection |
Support |
Over-current protection |
Support |
Industry Standard |
EMI: FCC Part 15B Class A RS: IEC 61000-4-3 80 MHz-1 GHz: 10 V/m EFT: IEC 61000-4-4 power interface: 4K;Ethernet ports: 2K ESD: IEC 61000-4-2 Level 4(8K/15K) Free fall: IEC 60068-2-32 Vibration: IEC 60068-2-6 |
Protection Level |
IP40 |
Installation Method |
Din Mounted |
Security Certificate |
CE/FCC/RoHS |
Working Environment |
Working Temperature: -40℃~75℃ Storage Temperature: -40℃~85℃ Relative Humidity: 5%~95%, non-condensing |
LED Indicators |
PWR(Power indicator), Green Color On: power status is normal
S(System indicator), Red Color On: Normal operation Off: Connection failure Blinking: Device initialization
Ethernet Port 1. Green Indicator On: port link up Off: port link down Blinking: data is in normal transmission
2. Yellow Indicator PoE ports On: PoE working Off: PoE not working
Fiber port, Green Color On: port link up Off: port link down Blinking: data is in normal transmission |
L3 Function
ARP |
ARP table aging |
DHCP server |
|
IPv4/IPv6 |
Static routing |
ECMP |
Support ECMP (Equal-cost multi-path routing) Support the configuration of ECMP Max next-hop Support capacity balanced configuration |
Route policy |
IPv4 prefix-list |
VRRP |
Virtual Router Redundancy Protocol |
Routing Protocol Specification |
|
RIP |
RIPv1/v2 |
OSPFv2 |
OSPFv2 |
BGP4 |
BGP4 BGP Support Routing Recursive ECMP Support to view the number of neighbors and up/down state |
IS-IS |
IS-ISv4 |
Routing entry |
13K |
L2 Function
Port aggregation |
Support GE port aggregation Support 2.5GE aggregation Support 10GE aggregation Support static aggregation Support LACP dynamic aggregation Up to 64 aggregation groups and up to 8 ports per group |
Port features |
Support IEEE802.3x flow control Support interface counters Support port isolation Port mirroring (One-to-One, Many-to-One) Support loop detection(Port-based; VLAN-based) Support broadcast storm suppression(broadcast; unknown multicast; unknown unicast) |
Mac-address table management |
Support static Mac-address management Support dynamic Mac-address Management Support filtering Mac-address Support MAC limit based on port and VLAN Support MAC flapping based on port and VLAN |
VLAN |
Support access mode Support trunk mode Support hybrid mode |
VLAN classification |
Mac Based VLAN IP Based VLAN Protocol Based VLAN |
GVRP |
Normal mode Fixed mode Forbidden mode |
QinQ |
Port-based QinQ VLAN-based QinQ (VLAN-stacking; VLAN-mapping) Flow-based QinQ |
LLDP |
LLDP (Link Layer Discovery Protocol) |
Ring network protocol |
Support IEEE802.1D-STP Support IEEE802.1W-RSTP Support IEEE802.1S-MSTP Support G.8032 ERPS protocol, single ring, sub Ring and major ring Recovery time ≤20ms |
L2 Multicast |
|
IGMP snooping |
Support IGMP snooping |
Group address |
Support group address |
Security Function |
|
ACL |
IP Standard ACL MAC extend ACL IP extend ACL IPv6 ACL |
QoS |
Support QoS Class, remarking Support SP, WRR queue scheduling Ingress port-based rate-limit Egress port-based rate-limit Support policy-based QoS |
802.1x |
Port access control Mac-address access control RADIUS server |
Port-security |
Port-security |
IP source guard |
IP Port/MAC binding |
ARP-check |
Support ARP-check and ARP packet filtering for illegal users |
Access control |
Support Telnet/SSH/HTTP/HTTPS user access control |
Management&Maintenance Function |
|
User Management |
Support password protection Support user authorization management |
SNMP |
Supporting SNMP V1/V2C/V3 version |
Web Management |
Web Management Support HTTP V1.1 Support HTTPS |
CLI management |
Console/Telnet command line management |
RMON |
Support RMON(Remote Monitoring) alarm |
Firmware upgrade |
Firmware upgrade |
Fault Detection |
Ping/Tracerout Dying gasp Support optical transceiver DDM function |
Cable detection |
Support copper port cable detection |
PoE Management |
Support 802.3af/802.3at Support PD watchdog Support PoE priority management Support Max PoE power configuration for each port Support alarm waterline configuration Support reserved power configuration |
NTP |
Network Time Protocol |
Syslog/Debug |
Syslog/Debug Syslog send to two servers |
Configuration import/export |
Support FTP/TFTP remote import/export |
Dual partition management |
Support dual partition switching |
Application Protocol Function |
|
DHCP Snooping |
DHCP snooping trust port Support remote-id/circuit-id configuration DHCP option-82 |
DHCP client |
Support DHCP client |
Telnet server |
Support telnet server |
Telnet client |
Support telnet client |
SSH server |
Support SSH server |
TACACS |
Support TACACS(the terminal access controller accesses the control system) |
SFlow |
Support network traffic analysis |
TFTP |
Support TFTP Client |
Mechanical Drawing
Packing List
- 1pc switch
- 1pc user manual
- 1pc console cable
Shipping box information(Below information is approximately accurate)
Product size: 158*115*54mm
Inner box size: 230*180*70mm
Product weight: 1.2Kg
Packing weight: 1.4Kg
Master box size: 440*375*250mm
Packing quantity: 12Pcs
Packing weight: 18Kg